SRX

I have 2 SRX340 firewalls that have lost access to SSH. SSH access was locked down to the main data center subnet. Long story short the site-to-site VPN between the data center and these two sites is down. At other sites with this issue, I was able to log into Jweb and add a new subnet to SSH from to the policy-options > prefix-list, and that worked fine. Unfortunately, these two sites go to the setup wizard when logging into jweb and I can't seem to get around it to add the new subnet. Is there any way to load the full jweb when the SRX keeps loading the setup wizard. Note that the two units throwing the setup wizard have been in production for at least a year.

Are you able to connect via cli and check the web management configuration.

show configuration system services web-management

I can't find the documentation but seem to remember there is some statement here that gets removed after the wizard is run and might still be in your configuration.

I have 2 SRX340 firewalls that have lost access to SSH. SSH access was locked down to the main data center subnet. Long story short the site-to-site VPN between the data center and these two sites is down. At other sites with this issue, I was able to log into Jweb and add a new subnet to SSH from to the policy-options > prefix-list, and that worked fine. Unfortunately, these two sites go to the setup wizard when logging into jweb and I can't seem to get around it to add the new subnet. Is there any way to load the full jweb when the SRX keeps loading the setup wizard. Note that the two units throwing the setup wizard have been in production for at least a year.