You can use VLANs to present multiple networks to the SSR WAN interfaces. I have a SSR 130 working that uses the same ge0/0/2 interface for the LAN and WAN. Within the WAN interface, simply add a VLAN number for the VLAN you want to use. Create a new WAN interface for each sub-interface you want to add, and add in the appropriate VLAN identifier.
You will just need to trunk the relevant VLANs into the relevant designated WAN ports. I did seem to have an issue with using VLAN 1, but I might have done something wrong.
Hope this helps and good luck.
------------------------------
ALAN LAVIS
------------------------------
Original Message:
Sent: 02-06-2025 15:35
From: HOGR OMER
Subject: I need help to Configuring SSR130 with EX4100
Hi Everyone!
I have two MPLS link that connecs two branchs to the HQ and two additional ISP From COX and AT&T. so basically I have 8 Uplinks with diffrent /30 subnet for each link.
I have two EX4100-24Port and 2 SSR130, my question is what is the best way to connect all the uplinks and route them together to my LAN? since my SSR130 doesn't have enough WAN port I am planning to connect EX4100 between the WAN and SSR130.
I appreciate any other idea and configuration solution.
------------------------------
HOGR OMER
------------------------------