Switching

Hello,

I am trying to upgrade an EX4300 MP using USB(format Install), but I'm getting the following :

 
usb 3-1: device descriptor read/64, error -110
xhci_hcd 0000:00:14.0: Setup ERROR: setup context command for slot 1.
usb 3-1: new high-speed USB device number 3 using xhci_hcd
usb-storage 3-1:1.0: USB Mass Storage device detected
scsi6 : usb-storage 3-1:1.0
Mounting boot device LABEL=USB-INSTALL
mount: can't find LABEL=USB-INSTALL
boot device mount failed

bash: cannot set terminal process group (-1): Inappropriate ioctl for device
bash: no job control in this shell
root@(none):/# scsi 6:0:0:0: Direct-Access     General UDisk         5.00 PQ: 0 ANSI: 6
sd 6:0:0:0: [sdb] 15728640 512-byte logical blocks: (8.05 GB/7.50 GiB)
sd 6:0:0:0: [sdb] Write Protect is off
sd 6:0:0:0: [sdb] No Caching mode page found
sd 6:0:0:0: [sdb] Assuming drive cache: write through
sd 6:0:0:0: [sdb] No Caching mode page found
sd 6:0:0:0: [sdb] Assuming drive cache: write through

sdb: sdb1
sd 6:0:0:0: [sdb] No Caching mode page found
sd 6:0:0:0: [sdb] Assuming drive cache: write through
sd 6:0:0:0: [sdb] Attached SCSI removable disk 

What process did you follow to create the USB drive, and what happens if you try a different brand of USB drive do you encounter the same error?

Regards,