Hello,
Juniper newbie here !
I have a cisco 4900m to juniper EX2300 trunked
Cisco trunk
interface TenGigabitEthernet1/7
description Juniper
switchport trunk allowed vlan 6,51,90,100-110,115,301-312,322,410,510-512,598
switchport trunk allowed vlan add 599,700,710-713,911,912
switchport mode trunk
end
show interfaces te1/7 trunk
Port Mode Encapsulation Status Native vlan
Te1/7 on 802.1q trunking 1
Port Vlans allowed on trunk
Te1/7 6,51,90,100-110,115,301-312,322,410,510-512,598-599,700,710-713,911-912
Port Vlans allowed and active in management domain
Te1/7 6,51,90,100-107,109-110,115,301-306,312,322,410,510-512,599,700,710-713,911-912
Port Vlans in spanning tree forwarding state and not pruned
Te1/7 6,51,90,100-107,109-110,115,301-306,312,322,410,510-512,599,700,710-713,911-912
Juniper
{master:0}[edit]
root@bob# show interfaces xe-0/1/0
native-vlan-id 1;
unit 0 {
family ethernet-switching {
interface-mode trunk;
vlan {
members [ wired1 wired2 wired3 cisco ];
}
storm-control default;
}
}
{master:0}[edit]
root@bob# show vlans
cisco {
vlan-id 911;
}
default {
vlan-id 1;
}
wired1 {
vlan-id 301;
}
wired2 {
vlan-id 302;
}
wired3 {
vlan-id 303;
}
root@bob# run show interfaces xe-0/1/0 terse
Interface Admin Link Proto Local Remote
xe-0/1/0 up up
xe-0/1/0.0 up up eth-switch
{master:0}[edit]
root@bob# run show interfaces vme terse
Interface Admin Link Proto Local Remote
vme up down
vme.0 up down inet 172.22.74.21/27
I can't even get the vme to come up !
{master:0}[edit]
root@bob# show interfaces vme
unit 0 {
family inet {
address 172.22.74.21/27;
}
}
Any help is really appreciated
------------------------------
DARREN HITCHEN
------------------------------