SRX

I have configured the 'auto-snapshot' feature on my SRX and EX devices, however it is showing as 'Disabled', as below. How can I enable it? There appears to be no relevant set command and the available Juniper documentation is customarily lacking. Perhaps I have misunderstood the meaning of 'State' here. I wonder then, if there is another way to confirm whether the automatic snapshot feature is working as intended.

>show system auto-snapshot      
Auto-snapshot Configuration:   Enabled
Auto-snapshot State:  Disabled

That 'Disabled' should really be 'Idle' (or perhaps 'Ready') ... It's fine, that output is normal.

https://www.juniper.net/documentation/us/en/software/junos/cli-reference/topics/ref/command/show-system-auto-snapshot.html

https://community.juniper.net/discussion/junos-in-primary-and-back-up-partition

------------------------------
Nikolay Semov
------------------------------

>show system auto-snapshot      Auto-snapshot Configuration:   EnabledAuto-snapshot State:  Disabled