SRX Next-Gen Firewalls

Thx, Avinash Kumar. I welcome more talk on experiences!!! B-) ------------------------------ Adrian Aguinaga B.S.C.M. I.T.T. Tech (Construction Management) A.A.S. I.T.T. Tech (Drafting & Design) ------------------------------

Good day, We use a off-site backup location with a ipsec tunnel. The max speed we get is 250mbps. for our purpose this is no issue. We get the bellow warnings indicating that the srx320 is running at max capacity. following the datasheet the ...

One interface will be assign to fxp0 interface. That's why ge interface showing N-1 of EVE-NG interface ------------------------------ Avinash Kumar ------------------------------

Hello ILYA PETRASHKEVICH , Try to add these commands and then check. https://www.juniper.net/documentation/us/en/software/secure-connect/secure-connect-user-guide/topics/task/local-auth-with-local-ip-pool-cli-procedure.html set services ssl ...

Hello eugene1973 First of all, Its SRX family ethernet-switching will not work until l2-learning is enabled. Secondly, It can work as uplink or downlink or can be both via vlan tagging. Third, I have used it with fiber. DAC should also work but ...

Perhaps the rule of thumb applies here that you cannot get past what seemingly looks like an operator type error. When I say operator I mean the => operator. If immediately after follows a 0 at some point we are sure that is an integer error. If it's ...

This message was posted by a user wishing to remain anonymous Nikolay Semov , thank you for reaching out. I have seen that link before, but unfortunately, it doesn't address my specific issue. I've had similar situations where the device would ...