Switching

Hi Everyone, Just to update on this problem. I have clear out all the configuration from the EX4100 switch and started building the configuration again. What I did was the following. a) remove the 2 lines for phone-home configuration b) Update ...

Please check this solution. I think it should works for you. https://www.juniper.net/documentation/us/en/software/junos/multicast-l2/topics/topic-map/rtgs-on-lags.html If you need your links work in active-backup mode between switches, you need ...

I have a strange problem on a brand new EX4100 switch that I need help on. The brief overview is that if I configure manually a static IP address on the workstation1, it can ping its own vlan gateway, other vlan gateway, and can access the internet. ...

I think ISP provide us QnQ tunnel, not sure. Yes, I am using 2 different ISP between location, I want to aggregate ISP into single aggregation port so that I got redundancy, I will be able to configure link-protection primary/backup feature on aggregation ...

duplicate

When a validation fails, where are the reasons for the failure logged ? Regards Simon Validating on fpc0 Setting up /var/tmp/v for validation ... Checking compatibility with configuration Initializing... Using junos-ex-20.4R3.8 Verified manifest ...

In another thread, I mentioned that I have a script which renames uploaded Juniper config files and stores them in git. Here is info on that. Since this is written specifically for my own setup, you'll need to adapt each script. First, you need a ...