vMX

 View Only
last person joined: 15 hours ago 

Ask questions and share experiences about vMX.

Welcome!

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Documentation Knowledge Base Security Advisories

Latest Discussion Posts

  • What version of VMX?? also are you configuring the mgt vrf prior to this setting? # set routing-instances mgmt_junos description "Mgt stuff" ------------------------------ ArtStine Virtualization/Kernel team --------------------------- ...

  • This message was posted by a user wishing to remain anonymous I am experiencing a vLabs issue where using this command user@host# set system management-instance user@host# commit hangs the router. I am in the "OSPF - Multi-area" vLab and experience ...

  • Hi everyone, I am curious about 4:1 after control word when we set up targeted LDP session with remote PE say 2.2.2.2 ? Unfortunately, I did not find an info on google. 2.2.2.2:CtrlWord:4:1:Local/96 Thanks!! ------------------------------ ...

  • This was usefull for me due to i realised that i should make a new dhcp-relay configuration inside the VRF. it worked for me thanks! ------------------------------ TORRECILLA GABRIEL ------------------------------

  • Hello, We are encountering an issue with an MX240 device that we are using as a LNS. Specifically, we are trying to assign a unique MAC address to each unit of an aggregate interface ( ae ). This is necessary because our provider requires us to have ...

  • Profile Picture

    Looking for help with an SRX configuration -

    This message was posted by a user wishing to remain anonymous Have six SRX345 units off a core network -- each one in a /24 network. Units two - Six seem to be working but the Master Site does not. All six are one-one NAT (at least I think ...

  • The example is using interface not zone as the match. And I assume since you are reference reth1 this should also be interface and not reth1z But if you do want to reference zones then there is a dash in the command to-zone set security nat source ...

Unanswered Posts

Top Contributors in the Community