Routing

 View Only
last person joined: 4 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • I used to configure in the following ways: provider-tunnel ldp-p2mp provider-tunnel rsvp-te label-switched-path-template default-template Anyone can tell me what are the differences if conigured in the following way provider-tunnel pim-asm ...

  • I have the following topology My issue is: The receiver (10.74.42.38 ) reports group 255.239.0.0. CE and RR have PIM join for all the 3 source subnets, but QFX10008 has only PIM join sourcing from 10.146.30.0/24, no sourcing from 10.146.32.x/24 ...

  • Are separate route reflector appliances best practice or is there alternative solutions you have used? We re-use MXs as our route reflectors. MX204s could be a good lower end cost RR if you already had them. You can achieve the same with a sufficiently ...

  • This problem occurs when the power loss boot/reboot corrupts the running primary disk partition and boot is not longer possible. As a result the device boots from the backup disk partition. The backup partition must be kept in sync with the primary ...

  • Hi Andrei, thank you for the message. Yes, I know both links, We have configured both inet and inet6 for LDP. And set the transport-preference to v6. The main issue here is the Juniper <> Nokia communication. Between Juniper <> Juniper ...

  • hello We faced eletrical shutdown on 2 ACX2200 wich caused a reboot of both of the equipments. During this reboot, the configuration automaticaly loaded by the equipement was and old and osbolete configuration and Junos software. you will have ...

Announcements

  • AI-Driven Support via JSI

    Get AI-driven support by connecting your devices to Juniper Support Insights (JSI). Join one of our upcoming “Jumpstart JSI Ask the Experts” meetups to learn more about JSI and ask the panel of experts your questions. Select the session that best suits your schedule:

    Tuesday, June 25 from 8:00-8:45PM PT: Register Now
    Wednesday, June 26 from 8:00-8:45AM PT: Register Now

Unanswered Posts

Top Contributors in the Community