Wireless

Hi, It's a 6-pin JST-style serial console interface used by Juniper for factory diagnostics, low-level debugging, and RMA purposes. And not meant for regular use. ------------------------------ MADHAN KUMAR G ------------------------------

Hi All, Ive been through all the documation that i can find for the AP43 and cant find any information on the pins at the back of the device: Does anyone know what it is and what it does and how to connect to it? Thanks in advanced ------------------------------ ...

Hi, Thanks for your reply. Please find below the responses against your questions: You mentioned turning off 2.4 Ghz, but your screen shot shows it enabled, and the dual-band radio settings set to 2.4 Ghz only. What are you trying to accomplish ...

Please find below responses against your queries: Snap shot shared was the old one, now we are also disabled 2.4 Ghz band on both RF template and SSID to see if 5 Ghz band is working on AP, but is not. Yeah we already done the troubleshooting and ...

Some thoughts: You mentioned turning off 2.4 Ghz, but your screen shot shows it enabled, and the dual-band radio settings set to 2.4 Ghz only. What are you trying to accomplish with these RF settings? If I were in your shoes, I would take one of ...

Could someone please assist with this issue? We are still experiencing a problem where certain Android smartphones can connect to AP 33 on the 5 GHz band, but the same devices cannot connect to other AP 33 units. All access points are part of the same ...

Alright, we have enabled the RF template again with 2.4 Ghz has been disabled on the WLAN template. Can you please check the RF template either its correct? Also my personal laptop is getting connected to the nearest AP on the 5 GHz, whereas the ...