Log in to ask questions, share your expertise, or stay connected to content you value. Don’t have a login? Learn how to become a member.
If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!
Need additional guidance? Check out these Juniper Resources.
Ask AI Juniper Threat Labs SRX Upgrade Guide Security Advisories
This message was posted by a user wishing to remain anonymous Hello, I am attempting to figure out what subscriptions are needed to connect an SRX1600 to Mist. The SRX1600 product page mentions it can be managed by Mist. The SRX1600 setup page says ...
The Switching Fabric is not involved. ------------------------------ Denis Rasskazov ------------------------------
# show chassis cluster reth-count reth-count 22; --- Both nodes have been updated , but the problem has not been resolved # run show version brief node0:
What is the configuration of the switch ports attached? A common error is to treat RETH (redundant ethernet) as if they were an aggregated ethernet pair. When this happens packet loss occurs because the switch is expecting to use either of the two ...
because it's not apart of the provided config, i'm asking, do you have a security policy for from-zone sale to-zone untrust?
set chassis cluster reth-count 12 Perhaps that does the trick? Oh, and do upgrade to 23.4R2-S4!
Good afternoon. Input data: SRX1600 * 2 = cluster (HA, redundancy group, etc...) An reth#.# interface is attached to the untrust zone A public address of the inet family has been added to the reth#.# interface. The ping from outside is successful. ...
Complete this three-question survey to help us identify where you are in your upgrade journey.