Switching

Seeing a similar issue with EAP-TLS on a Juniper EX4100 switch. Server certificate received from RADIUS server and client attempts to send client certificate but the packet is fragmented and it appears the switch does nothing with it. Any updates on this ...

Yes it does this behaviour running Juniper's recommended version 23.4R2-S4 as well as the newer v24.2R2.18 and older versions 22.4R3.25 and 23.4R2.13 and they all do the same thing. The switches are past their 90 day post sales support so raising it with ...

All the switches EX 2300s in our inventory have the same firmware, 23.4R2-S4.11. We're using RSTP There are three VOIP phones plugged into the EX2300 named SR. The profile they use has the standard data ports set as an edge device. The ...

A head scratcher for sure...... I would compare the entire config of those two against a known switch to not have these issues.... the rv switch appears to have auto-snapshot enabled, and may be doing it too often from the syslog msg....you ...

In the case of the switch named RV I swapped out a DAC cable for a new SM fiber and a pair of SFPs. This switch is daisy-chained to a primary switch in the IDF rack. This did not resolve the issue. The switch named SR has a single-mode fiber home run ...

Here is a sparse definition of the LCBM syslog: The syslog message "LBCM-L2,brcm_ifl_l2_init()" is related to the initialization of Layer 2 interfaces on devices using Broadcom chipsets. This message typically appears in the context of control plane ...

All the schools are setup the same. A core EX4600 fiber switch that all the IDFs feed to and the 4600 is the site router and gateway to the data center for all the outbound traffic. Since I only have 2 switches in the inventory of 350 switches that are ...