Routing

 View Only
last person joined: 20 hours ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: DAVID CRIOLLO , 16 hours ago

    Even though this statement was lacking too Stuart also found the issue. R1 set protocols ldp interface lo.0 set protocols mpls interface ge-0/0/0.0 set protocols mpls interface ge-0/0/2.0 R2 set protocols ldp interface lo.0 set ...

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: DAVID CRIOLLO , 16 hours ago

    It worked, root@R1# run show l2circuit connections Layer-2 Circuit Connections: Legend for connection status (St) EI -- encapsulation invalid NP -- interface h/w not present MM -- mtu mismatch Dn -- down ...

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: STUART RIDSDALE , 17 hours ago

    Pretty sure you need to enable LDP for the loopback for the targeted LDP session to work and exchange the VPN label. Try adding: R1 set protocols ldp interface lo.0 set protocols mpls interface ge-0/0/0.0 set protocols mpls interface ge-0/0/2.0 ...

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: DAVID CRIOLLO , 17 hours ago

    No it changed to OL---Not outgoing label. I have attached the configuration. [edit] root@R1# show | display set set version 20191026.124700_builder.r1063854 ...

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: MFB , yesterday

    Based on your configuration it seems you are using dedicated interframes and not vlan tagged. Direct under your interfaces add encapsulation ethernet-ccc and make sure you have unit 0 only.

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: MFB , yesterday

    Good Day, please check the configuration under the interface itself as well. You need to enable the encapsulation type for this service under the interface.

  • Profile Picture

    RE: L2Circuit No comming up - ST: NP

    By: Grzegorz Dacka , yesterday

    Hello NP means as written NP -- interface h/w not present Do you have UP link inserts or UP port ? ------------------------------ -- Grzegorz Dacka ------------------------------

Announcements

  • Introducing Juniper Support Portal (JSP) Mobile App for iOS

    The Juniper Support Portal (JSP) Mobile App is now available for customer use on iOS platforms. The app is designed to provide mobile access for on-the-go service support. 

    What’s available?

    • Live Chat Support
    • Instant Notifications
    • Knowledge Base Access 

Unanswered Posts

  • MS-MPC UDP Flood

  • Pause Frame Handling on Junos

  • Segment routing: What is the purpose of announcing ...

  • Evpn-vxlan Stitching using MAC-VRF with Gateway interconnect ...

  • COS: What is buffer-delay rate?

  • NTP server x.x.x.x prefer

  • BGP Flow spec: How to view dynamic filter

Top Contributors in the Community