Routing

Hi @spuluka , I have additional question. Do we need to allow port 10179 in protect-RE for "station port" as per below config? Appreciate your feedback bmp { local-address x.x.x.x; connection-mode active; monitor enable; route-monitoring ...

Hi all, May i know whether we can do sampling jflow9 on AMS interface at SPC3-MX-CGNAT. The objective is to get the info regarding all the traffic CGNAT session such as private ip and NAT source. Thanks and appreciate any feedback

Hello, I'm trying to set up an inter-AS l2circuit using inter-AS option 10C and cannot ping across the l2circuit. I can' seem to find any documentation or if this is even possible. My l3vpns are working fine between and INTRA-AS l2circuits work fine. ...

I have found solutions for similar fault cases from other BRAS manufacturer, but I don't know how to fix it on the Juniper MX960.: Problem description: PPPoE IPv6 user, configured with statefull address allocation, can get IPv6 addresses. ...

1. Problem description: PPPoE users can get IPv6 addresses through DHCPv6 stateful address assignment, but cannot communicate with other IPv6 hosts. 2. Topology: PC(windows 10, PPPoE client)<----Swtich(Pure L2)---->BRAS(PPPoE Server) ...

This message was posted by a user wishing to remain anonymous Hello, Wondering if anyone has their Juniper MX480 routers configured in an ERPS ring with Nokia Lightspan MF-2 OLT ring and the configuration used to get it to work? We have had no success ...

This message was posted by a user wishing to remain anonymous I have the same issue, on the same platform, as described here. Has anyone got any suggestions?