Routing

The provide-tunnel I used is pim-asm For each vrf mvpn, a pair of mt- interfaces are automatically created as follows: root@PE-1# run show pim interfaces instance demo Name Stat Mode IP V State NbrCnt JoinCnt(sg/*g) DR address lo0.4 ...

hi guys. in our company we have a MPLS backbone with 70 nodes ( MX 204, MX 10003 and 10008) router. We are currently usin 4 MX 10003 routers as a root reflector cluster. No, we want so secure the ruster to make it Now we want to secure the cluster ...

Hello Steve, thank you for responding to my post. I actually checked the that before, but dual stack was not listed in the supported feature. I would like to know if PTX10002-60C is capable to run both IPv4 and IPv6 to the same physical or logical interface. ...

All the Junos platforms support ipv6, but there are differences in the details and Junos versions required. You can use the Juniper Feature Explorer site to confirm what features are supported. From this link > Select your platform > then the Junos ...

We are planning to replace our core routers from MX480 to PX100002-60C to expand the 100G port density. One of the requirements we have in our network is a support of dual stack for ipv4 and ipv6 addresses. My question is, do PTX10002-60C support dual ...

Good morning, After having posted this to the DataCenter community, and being "without response" for around 1 month, I thought this community might be a better bet (I couldn't see how to cross-post a post once it had already been published, hence ...

With all due respect I don't think you understand. I'm talking about what leaf1 is doing inside the L2 virtual switch. Traffic never reaches the PE. The vrf config is irrelevant here. Sent from my iPhone On 6 Sep 2024, at 06:34, FARID AKHUNDOV ...