Switching

Hi, The procedure is sound, just don't pull the wrong cable 🙂 fpc 4 will not become fpc 1 unless you renumber it, this would disrupt traffic forwarding. Also now that you have a 2 member virtual chassis you should enable ...

Hello, VME port's use is entirely different. You can refer to the KB below for the same: <<This article has been archived and the link is no longer valid. The link was removed on June 23, 2025.>> I don't think you can achieve what you ...

.Hi there, for the vme interface to come up you need to delete the configuration of the other management interfaces, the vme will be setup as a virtual management interface and you will be able to reach it through the management interface of any ...

There is LOTS of info out there about how to set-up a VC, but maybe start here: https://www.juniper.net/documentation/en_US/junos/topics/concept/virtual-chassis-ex4200-components.html One item missing is the fact for a 2-member (only) VC ...

By default, during any JUNOS upgradation, new JUNOS version validiate consistency of the current active configuration with its feature library. Hence, you may use command request system software add /...... / no-validate to avoid such errors. ...

The problem seems to be your Cisco router. Make sure it is configured to source NAT from these other internal nets and that it has a route back to these internal nets. ------------------------------ TED TANG ------------------------------

Basically if I "ping interface [interface] [IP] where IP equals the configured gateway from any other interface except the one configured I get "no route to host". ------------------------------ JIM VADEN ------------------------------