SRX Next-Gen Firewalls

ISP1 and ISP2 are connected via the internet. They should be able to reach each other. In your configuration snippet, it looks like you're importing interface routes (a.k.a. Direct routes) into New-route-table. If that's the case, then traffic going ...

Nikolay, " And in any case, I also don't see how pinging gateway addresses from an external device (your phone) is relevant to your original question about Filter-Based Forwarding." If both paths, ISP1 and ISP2 can discover a way to the Gateway ...

Sounds like hard reset or contacting Juniper for this one: https://supportportal.juniper.net/s/article/SRX-Stuck-at-boot-stage-3-after-attempting-a-Routing-Engine-BIOS-U-boot-firmware-upgrade?language=en_US ------------------------------ Nikolay Semov ...

I'm getting lost a little bit in what you mean about "finding" "it," " local static route," and other aspects. Your configuration snippet is extremely limited, so I'm not sure I have a good picture of what you're dealing with and what you're trying to ...

This message was posted by a user wishing to remain anonymous Hello , I am currently experiencing an issue with my Juniper SRX300 device. Upon booting, I encounter errors related to the SPI stage 3 bootloader. Below are the details of the ...

Thank you Nikolay, kudos!!!! Does anyone else have commentary!!!! ------------------------------ Adrian Aguinaga B.S.C.M. I.T.T. Tech (Construction Management) A.A.S. I.T.T. Tech (Drafting & Design) ------------------------------

Nikolay, I need to confirm our gateway on the primary ISP. What I have in my records can be seen outside our network. I can ping it from a device on cell service. That means even going out our secondary ISP could still find it. That would mean using ...