Security

Elevate Community & Juniper Customers: Here at Juniper, we recognize upgrading your SRX can be a challenging and delicate process. For this reason, we developed the SRX Upgrade Guide documentation to assist you. This guide has you covered from what ...

Hi everyone, I am wondering if there is any command to view dynamic filter that is created as a result of receiving BGP flow spec route. For example: Below EM-EXT-SW has created a dynamic filter " __flowspec_default_inet__" As per Juniper, it ...

So it sounds like the primary routing for the site would always use ip2 while you want the VPN to override this and use ip1 instead. So I would setup the routing override using KB above that would setup match criteria for UDP 500 and a destination ip ...

Sadly, I can't open the site you sent; it says the site is temporarily unavailable. (I'll check it later.) I'm trying to clarify the issue I'm facing since you mentioned that you're not sure you fully understand the problem: Most of the time, I don't ...

I'm not sure I follow the whole issue, but it sounds like you might be able to use the source based routing option for this problem. This will use the criteria of the source address to select the routing path and can also be combined with destination ...

Hi all, I'm managing a site-to-site VPN for one of our clients, and I've run into an unusual routing issue that I'm hoping someone here can help with. The setup is such that, unlike other clients, this one requires a specific static route to get the ...

Have I stumped the group? ------------------------------ JOHN WILLIAMSON ------------------------------