SRX Next-Gen Firewalls

Understood, I don't know off hand if there is a command available to verify the integrity of the drive itself, obviously the fact that it's not able to receive the transfer is an indicator that something isn't. Performing a media install from an attached ...

I think this is effectively what I'm doing, except rather than grabbing the file from a USB drive, I'm grabbing it from a tftp server. (This particular device is in a space where it would be difficult or impossible to use a USB drive.) I suspect what's ...

Syslog Server n.n.n.n is not getting data at all, or not getting data from node1? Keep in mind that a reth interface can only be active on one of the two nodes at a time. ------------------------------ Nikolay Semov ------------------------------

Hi, I've spent some time getting syslog working for a active/passive SRX340 cluster. I have set up: node0 { system { host-name myhost-node0-srx; syslog { host n.n.n.n { any notice; authorization ...

You might find this support article useful. https://supportportal.juniper.net/s/article/Recovering-the-device-when-stuck-in-boot-load-for-SRX300-series?language=en_US Regards,

I've upgraded a SRX345 and SRX300 following this link - best to backup your config and have a console access during upgrade: I'm now on srx24.4r1-s2 which is lot more stable... SRX300-series requirements for upgrade to Junos 24.4R1 and higher ...

We have a Juniper SRX320 that I was trying to upgrade to the latest Junos 24.4, but has given errors during that process. It was functional running 20.2R3-S2.5 with a basic config to allow network connectivity and ssh access. Following TSB92728 , ...