SRX Next-Gen Firewalls

Yes, the monitor commands only capture routing engine traffic. For transit traffic, see one of these articles depending on what model you have (the SRX series the instructions apply to are listed in the articles): https://supportportal.juniper.net/s/article/Includes-video-How-to-create-a-PCAP-packet-capture-on-a-SRX-branch-device?language=en_US ...

Thanks Spuluka, but I found that the traffic that passes through the firewall can't appear in the monitor command, we can see it by the (show security flow session) and if we need to export it we should take a PCAP from both interfaces (reth, and ...

There is a procedure to access the console port, and then shell to the actual configuration command line. You're guaranteed to get proper setup after this. You certainly can find it on the web, but maybe you need to ask juniper representatives because ...

I found the problem My SRX1500 ran out of space. Its stupid that it does not have a scheduled system clean up. ------------------------------ JOHN HARRISON ------------------------------

Hi, Have you tried to do a "restart web-management"? Regards Anders ------------------------------ ANDERS SKALME ------------------------------

There are two commands for checking the traffic on an interface and their use can be confusing as they are simply a different order for the same words. monitor traffic interface - as you can see from your testing, this command only shows traffic that ...

Dear Nikolay, Good day! Thanks for your reply. As you mentioned above, the package 'srxjcp' was not the right package. When i tried 'srxentedge-' package, no any problem occur. Thanks for your confirmation, and happy ...