Switching

Hi, I tried both scenarios with MAC RADIUS (not .1x) and Mist NAC. In both cases, if the first host authentication failed, the other hosts could authenticate successfully at times, after the re-authentication attempts post the quiet period. However, ...

Hi, Please refer to the below link for the possible options https://www.juniper.net/documentation/en_US/release-independent/information-products/topic-collections/hardware/ex-series/ex3200-4200/virtual-chassis-hardware-cabling.html Regards ------------------------------ ...

Yes, cable them in a ring. ------------------------------ David Divins ------------------------------

We've recently moved from EX4200 switches to new EX4100. When cabling the EX4200, the VCP cables were connected in a Ring setup. Does the EX4100 need to be cabled the same way? ------------------------------ Chris Phillips ------------------------- ...

Hi all. In EVPN-MPLS, the sole purpose of the Type 1 per-EVI route is to communicate an aliasing MPLS label. In EVPN-VXLAN, there is no MPLS, hence no use of an aliasing MPLS label. Does that mean that in EVPN-VXLAN, the Type 1 per-EVI route ...

If you don't get any output on the console likely the internal drive was damaged too significantly in the multiple boot loops to work now. If you have an operational device, I would create a bootable usb using the snapshot command. request system ...

During some maintenance on one of our racks it seems that the power cable to one of our QFX5100 switches came loose and may have been switching on/off rapidly for a some seconds before falling out of the socket completely. Now the switch does not power ...