Switching

Interestingly, the EX3400 hardware guide has no warnings (that I can find) regarding mixing AC and DC! You can compare the EX4300 and EX3400 hardware guides yourself. In the EX4300 power section, warnings are there, but not for the EX3400. https://www.juniper.net/documentation/us/en/hardware/ex3400/topics/topic-map/ex3400-power-system.html ...

Have you had any clarification on this yet? I'm interested in this as well. I have a scenario where I'm switching over from an EX3300 to EX3400. Ideally, I'd like to power up the EX3400 with a single AC power supply, then swap out all the connections ...

Hi, I tried both scenarios with MAC RADIUS (not .1x) and Mist NAC. In both cases, if the first host authentication failed, the other hosts could authenticate successfully at times, after the re-authentication attempts post the quiet period. However, ...

Hi, Please refer to the below link for the possible options https://www.juniper.net/documentation/en_US/release-independent/information-products/topic-collections/hardware/ex-series/ex3200-4200/virtual-chassis-hardware-cabling.html Regards ------------------------------ ...

Yes, cable them in a ring. ------------------------------ David Divins ------------------------------

We've recently moved from EX4200 switches to new EX4100. When cabling the EX4200, the VCP cables were connected in a Ring setup. Does the EX4100 need to be cabled the same way? ------------------------------ Chris Phillips ------------------------- ...

Hi all. In EVPN-MPLS, the sole purpose of the Type 1 per-EVI route is to communicate an aliasing MPLS label. In EVPN-VXLAN, there is no MPLS, hence no use of an aliasing MPLS label. Does that mean that in EVPN-VXLAN, the Type 1 per-EVI route ...