Switching

Yes, cable them in a ring. ------------------------------ David Divins ------------------------------

We've recently moved from EX4200 switches to new EX4100. When cabling the EX4200, the VCP cables were connected in a Ring setup. Does the EX4100 need to be cabled the same way? ------------------------------ Chris Phillips ------------------------- ...

Hi all. In EVPN-MPLS, the sole purpose of the Type 1 per-EVI route is to communicate an aliasing MPLS label. In EVPN-VXLAN, there is no MPLS, hence no use of an aliasing MPLS label. Does that mean that in EVPN-VXLAN, the Type 1 per-EVI route ...

If you don't get any output on the console likely the internal drive was damaged too significantly in the multiple boot loops to work now. If you have an operational device, I would create a bootable usb using the snapshot command. request system ...

During some maintenance on one of our racks it seems that the power cable to one of our QFX5100 switches came loose and may have been switching on/off rapidly for a some seconds before falling out of the socket completely. Now the switch does not power ...

I assume you are pasting in commands in a terminal session. These will be limited by buffers on both the client and the application used. When transferring bulk commands a more reliable way would be to copy these in a plain text file to the device ...

Hello Juniper community- is there any particular settings or command I need to run to allow the EX4300 switch to run several lines of configuration at once ? It seems the switch cutting off config lines when it is more than four line thanks inadavace ...