Switching

The problem seems to be your Cisco router. Make sure it is configured to source NAT from these other internal nets and that it has a route back to these internal nets. ------------------------------ TED TANG ------------------------------

Basically if I "ping interface [interface] [IP] where IP equals the configured gateway from any other interface except the one configured I get "no route to host". ------------------------------ JIM VADEN ------------------------------

Hi all I've got an ex4650 that I've configured one interface with the IP of our upstream Cisco router and routing options next hop to that IP's gateway. From the switch I can now ping 8.8.8.8 as well as the gateway of that public IP configured in ...

Seeing a similar issue with EAP-TLS on a Juniper EX4100 switch. Server certificate received from RADIUS server and client attempts to send client certificate but the packet is fragmented and it appears the switch does nothing with it. Any updates on this ...

Yes it does this behaviour running Juniper's recommended version 23.4R2-S4 as well as the newer v24.2R2.18 and older versions 22.4R3.25 and 23.4R2.13 and they all do the same thing. The switches are past their 90 day post sales support so raising it with ...

All the switches EX 2300s in our inventory have the same firmware, 23.4R2-S4.11. We're using RSTP There are three VOIP phones plugged into the EX2300 named SR. The profile they use has the standard data ports set as an edge device. The ...

A head scratcher for sure...... I would compare the entire config of those two against a known switch to not have these issues.... the rv switch appears to have auto-snapshot enabled, and may be doing it too often from the syslog msg....you ...