Switching

 View Only
last person joined: 23 hours ago 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.

If you have a question or a use case, there are likely others experiencing or who worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Documentation Knowledge Base Day One Books Free Trial

Latest Discussion Posts

  • bonjour everybody, how about a quick licence tutorial ? our network internet access goes through a pair of EX4600 at a central location. Needless to say. one of them going down would be a major service interruption. So the organisation purchased ...

  • Greetings. I'm looking for some assistance with setting up port mirroing on an EX4300. I'm in a pickle because I am not a network guy. I'm filling in since our network guy left recently. I have some experience with other platforms, but I am completely ...

  • Profile Picture

    EX4600 Routing 80 & 443 traffic

    This message was posted by a user wishing to remain anonymous Hi Ascended beings, We currently have a Juniper EX4600 with a relatively basic setup that is passing all traffic to our gateway. We would now like to grab all port 80 & 443 traffic and ...

  • Hi, Can you validate vlan 100 or 1100? Also, are you using tagged or untagged vlan on the switch? Share your switch port configuration! ------------------------------ DIDIER KAMENI ------------------------------

  • Hi Bengisu, As of the switchport is configured in trunk mode with native vlan id 1100, the vlan configuration on the AP can be left blank. All untagged traffic from the AP will be assigned to vlan 1100 on the switchport as it arrives there. This will ...

  • Hi, I created an organization site in Juniper Mist. Then I created a switch template and assigned it to EX2300-48p model switches. I have AP24 Access Points connected to EX2300 swithces. APs get the IP address from the block they should get it from ...

  • Profile Picture

    LACP flaping between qfx1k and qfx5200

    This message was posted by a user wishing to remain anonymous We have a dark fiber (span is 32km) and we have a juniper qfx1k-36q in side a and we have a qfx5200-32c in side b (in side b it is 2x qfx5200-32c virtual chassis) and ...

Announcements

  • Introducing Juniper Support Portal (JSP) Mobile App for iOS

    The Juniper Support Portal (JSP) Mobile App is now available for customer use on iOS platforms. The app is designed to provide mobile access for on-the-go service support. 

    What’s available?

    • Live Chat Support
    • Instant Notifications
    • Knowledge Base Access 

Unanswered Posts

Top Contributors in the Community