Switching

Hi, Can the switch telnet to the RADIUS server on the required port? A successful connection confirms reachability on that port. If configured, test this from the relevant routing instance (e.g., mgmt_junos). For example, in the outputs below, telnet ...

Hello, I have quite a few EX4100s using 802.1x, but I'm not familiar with FortiNAC. My first thought is I wonder if there's any logging on the FortiNAC that you could look at. It might be helpful to see if requests are reaching the radius server ...

Thanks. In this case, however, the FortiNAC deployment is operating in Local RADIUS mode . Per Fortinet documentation, UDP 1645 is the default authentication port for Local RADIUS Server , whereas UDP 1812 is the default for Proxy RADIUS ...

1) To monitor a specific interface set forwarding-options analyzer MIRROR input ingress interface ge-1/0/7.0 set forwarding-options analyzer MIRROR input egress interface ge-1/0/7.0 set forwarding-options analyzer MIRROR input ingress interface ...

1) To monitor a specific interface set forwarding-options analyzer MIRROR input ingress interface ge-1/0/7.0 set forwarding-options analyzer MIRROR input egress interface ge-1/0/7.0 set forwarding-options analyzer MIRROR input ingress interface ...

That is correct, this because QFX5100 support two modes service provider or enterprise configurations. with l2circuits it needs to be in service provider mode. When you apply vlan-ccc encapsulation to an interface its process is mpls/l2circuit, so ...

For the MX: last supported JunOS with Routing Engines RE-S-1800 is 21.2. This RE will be End of Support (and actually End of All) within 2 months from now (and same thing for older SCBE, and MPCs like 16x10G, MPC2/MPC3 not-NG...). Those days, with more ...