Switching

I have made a little more progress, but not much. First, what I tried and that didn't work: I fired up one of my other 4300's and created a backup USB drive. The problem that I ran into though, is I could not get the switch to boot off of the USB ...

I have been unable to find anywhere in the Juniper manuals for EX4100-48MP switches what the meaning is for when a RJ45 ethernet network port status LED turns continuous red/orange instead of the usual green. It's only ever either port 00, 01, 02 or 03 ...

I see in the ex download area there is no img file with the standard ex-4300 but the EX4300 MULTIGIGABIT does have that USB img file. This might be worth a try. ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - ...

Thank you for your response. The problem that I have is that there is no Hit [Enter] to boot immediately, or space bar for command prompt. It does not exist during the boot process that I can see. If you look at my original post, I show the ...

When the following prompt appears, press the Spacebar to access the router's bootstrap loader command prompt. content_copy zoom_out_map Hit [Enter] to boot immediately, or space bar for command prompt. Booting [kernel] in 9 seconds... ...

Mark, I think that I am still missing a step. I copied the tgz file over to a FAT32 formatted USB stick (1 GB). Plugged it into the switch and powered on the switch. The switch still boots to the WindRiver linux, but it does say that it has 2 Storage ...

Ken, For the EX4300 (Not the EX4300-MP model) uses the same install file (.tgz) is also a bootable file from USB (or TFTP). There are no .img files for the EX4300. https://supportportal.juniper.net/s/article/EX-Performing-and-resolving-any-common-issues-during-Format-Install-on-legacy-EX-platforms?language=en_US ...