Switching

bonjour everybody, how about a quick licence tutorial ? our network internet access goes through a pair of EX4600 at a central location. Needless to say. one of them going down would be a major service interruption. So the organisation purchased ...

Greetings. I'm looking for some assistance with setting up port mirroing on an EX4300. I'm in a pickle because I am not a network guy. I'm filling in since our network guy left recently. I have some experience with other platforms, but I am completely ...

This message was posted by a user wishing to remain anonymous Hi Ascended beings, We currently have a Juniper EX4600 with a relatively basic setup that is passing all traffic to our gateway. We would now like to grab all port 80 & 443 traffic and ...

Hi, Can you validate vlan 100 or 1100? Also, are you using tagged or untagged vlan on the switch? Share your switch port configuration! ------------------------------ DIDIER KAMENI ------------------------------

Hi Bengisu, As of the switchport is configured in trunk mode with native vlan id 1100, the vlan configuration on the AP can be left blank. All untagged traffic from the AP will be assigned to vlan 1100 on the switchport as it arrives there. This will ...

Hi, I created an organization site in Juniper Mist. Then I created a switch template and assigned it to EX2300-48p model switches. I have AP24 Access Points connected to EX2300 swithces. APs get the IP address from the block they should get it from ...

This message was posted by a user wishing to remain anonymous We have a dark fiber (span is 32km) and we have a juniper qfx1k-36q in side a and we have a qfx5200-32c in side b (in side b it is 2x qfx5200-32c virtual chassis) and ...