Routing

 View Only
last person joined: yesterday 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • Hi John, If you want to have customer frames to be unchanged from start point to end point, you can use some kind of UNI port in terms of Metro Ethernet. It calls sometimes "transparent Ethernet" as it passes all types of frames. -----untagged ...

  • Hi, I have understood your concern. In mx and srx drop-probability linearly increasing. In qfx and ex switch it is different, just like the graph you mentioned. I have tested the same command "set interpolate fill-level 30 fill-level 50 drop-probability ...

  • Hello, The answer is C. OSPF preference is 10 , BGP preference is 170. Lower preference preferred. https://www.juniper.net/documentation/us/en/software/junos/routing-overview/bgp/topics/concept/routing-protocols-default-route-preference-values.html ...

  • Thanks Farid!! Wide metric is on by default on Juniper so extended TLV is also added, when enable wide metric only,is enabled , then internal TLV are suppressed., extended TLV are only present. But I was curious what would be the rational behind ...

  • Thanks!! This is so misleading. https://www.juniper.net/documentation/us/en/software/junos/traffic-mgmt-qfx/topics/example/tail-drop-profiles-cos-configuring.html Note no drop until the first fill level is reached 30 %, linearly increases until ...

  • The mode parameter sets if the relay is default open or closed for your requirement. Relay input selects the alarm criteria where the relay will switch to the other non-default position. Temperature alarm triggers are separate as you note. output ...

  • Hello i have a question very important and i want expert juniper to help me user@router> show route 192.168.100.2 inet.O: 15 destinations, 17 routes (15 active, 0 holddown, 0 hidden) Limit/Threshold: 1048576/1048576 destinations ...

Announcements

Unanswered Posts

Top Contributors in the Community