I have remplaced my SSG5 by a SRX100H2 on the same modem bridge ZYXEL.
It's unable to connect with SRX.
What's the problem!?
I have tested a lot of solution ...
PADI no response
set interfaces fe-0/0/7 unit 0 encapsulation ppp-over-etherset interfaces pp0 unit 0 ppp-options chap default-chap-secret <PASSWORD>set interfaces pp0 unit 0 ppp-options chap local-name <USERNAME>set interfaces pp0 unit 0 ppp-options chap passiveset interfaces pp0 unit 0 pppoe-options underlying-interface fe-0/0/7.0set interfaces pp0 unit 0 pppoe-options idle-timeout 0set interfaces pp0 unit 0 pppoe-options auto-reconnect 3set interfaces pp0 unit 0 pppoe-options clientset interfaces pp0 unit 0 family inet mtu 1492set interfaces pp0 unit 0 family inet negotiate-addressset routing-options static route 0.0.0.0/0 next-hop pp0.0set security zones security-zone untrust interfaces pp0.0
Nothing on PPPOE Problem on Belgium and PADI?
PPPOE negotiation is as below.
Client to server: Initiation (PADI)Server to client: Offer (PADO)Client to server: request (PADR)Server to client: session-confirmation (PADS)Either end to other end: termination (PADT)
As per the statistics you provided it looks like we are not reciving the PADO in response to the PADI we sent. PADI and PADO is used to communicate the MAC address and without this PPPOE will not work. Please check the other end why PADO is not sent when SRX sends the PADI.. Most probably a MAC learning issue on other end.
Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too
You're a god!
Thanks a lot!,