Switching

 View Only
last person joined: yesterday 

Ask questions and share experiences about EX and QFX portfolios and all switching solutions across your data center, campus, and branch locations.
  • 1.  Mejor Alarm Host 1 ECC single bit parity error

    Posted 06-24-2019 13:13

    Dear All,

    I am getting "Host 1 ECC single bit parity error" alarm in my Ex8216 switch. If possible, please share possible solution for it.

    Regards..
    Umesh Sharma | +91 9007743324

    bnrumesh@gmail.com



  • 2.  RE: Mejor Alarm Host 1 ECC single bit parity error

     
    Posted 06-24-2019 13:37

    Umesh,

     

    These could be a good place to start:

    https://kb.juniper.net/KB13791

    https://kb.juniper.net/KB2162

    https://kb.juniper.net/KB24159

     

    Cheers

    Pooja

    Please Mark My Solution Accepted if it Helped, Kudos are Appreciated too!!!



  • 3.  RE: Mejor Alarm Host 1 ECC single bit parity error

    Posted 06-24-2019 18:39

    thanks..



  • 4.  RE: Mejor Alarm Host 1 ECC single bit parity error
    Best Answer

     
    Posted 06-24-2019 13:48

     ECC = Error Correction Code.  This message is just a warning/informational, that SW determined there was an internal single bit error, and then went and correct.  This functionality prevents bit errors from being sent, but with a good L2 or data CRC.  To detect such errors, high level protocols must get involved, maybe up to application level for recovery.  This makes the transmission not very efficent.

     

    These errors are most often caused by small guiches in HW, where aging could be a factor.  If these errors continue to occur at an increase rate, then generally a HW RMA replacement is most likely the next step.

     

    HTH, Rich

     

     



  • 5.  RE: Mejor Alarm Host 1 ECC single bit parity error

    Posted 06-24-2019 18:38

    Thanks Rich..



  • 6.  RE: Mejor Alarm Host 1 ECC single bit parity error

    Posted 07-05-2022 11:55
    Hi 

    This alarm is exist  in the node (MX2008)from last 15 days.   Can we clear this alarm manually ?

    Thanks

    ------------------------------
    BHUPESH SHAKYA
    ------------------------------