Switching

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



Expand all | Collapse all

Show mac address for all devices connected to port

Jump to Best Answer
This thread has been viewed 23 times
  • 1.  Show mac address for all devices connected to port

    Posted 06-01-2022 17:47

    I am trying to see if Juniper has a similar command to show device mac addresses when devices are connected to a VOIP phone and then to the switchport.

    In the Cisco world a similar command will show both the mac address of the phone and the computer on the other end.

    I have found show ethernet-switching table, however it only shows the one

    Juniper
    root@sw-trial-1> show ethernet-switching table | match ge-0/0/12.0
    default d4:dc:09:19:94:43 D - ge-0/0/12.0 0 0

    Cisco
    show mac address-table interface g1/0/3
    Mac Address Table
    -------------------------------------------

    Vlan Mac Address Type Ports
    ---- ----------- -------- -----
    1 c81f.ead7.699a DYNAMIC Gi1/0/3
    500 c81f.ead7.699a DYNAMIC Gi1/0/3



    ------------------------------
    GRAHAM MURISON
    ------------------------------


  • 2.  RE: Show mac address for all devices connected to port
    Best Answer

    Posted 06-03-2022 06:24
    Hi,

    I would say that you are close. This command should do the trick (but your should list it as well):
    show ethernet-switching table interface ge-0/0/27