Routing

 View Only

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



  • 1.  Question on Multiple IP addresses on the Same Loopback Sub-interface

     
    Posted 14 days ago

    Hi.

     

    Why would an Enterprise router's loopback interface ever need multiple IP addresses on a single sub-interface as shown below?

     

    interfaces {

       loopback {

          family inet {

             address 172.16.1.1/32 {

                primary;

             }

             address 172.16.2.1/32;

             address 172.16.3.1/32;

             address 172.16.4.1/32;

          }

       }

    }

     

    Thanks,

    Deepak

     


    Juniper Business Use Only



  • 2.  RE: Question on Multiple IP addresses on the Same Loopback Sub-interface

     
    Posted 14 days ago
    I've only seen this in deployments of BNG for the gateway address of the subnets being managed. 

    I doubt that use case is found in the enterprise.

    ------------------------------
    Steve Puluka BSEET - Juniper Ambassador
    IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP - Retired)
    http://puluka.com/home
    ------------------------------



  • 3.  RE: Question on Multiple IP addresses on the Same Loopback Sub-interface

    Posted 14 days ago
    Multicast uses, such as MSDP and/or Anycast RP come to mind.