I just rebooted mine to verify.
On power up is your SYS light on the front of the switch blinking GREEN ? If not reset the switch
Then your RJ45 console port connection will will be showing the following for about the next 6.5 minutes.
---SNIP---
RAM Configuration:
Bank #0: 60000000
DRAM: New Stack Pointer is: dfec4ee0
Relocation Offset is: eff15000
Relocating to dff15000, new gd at dfec4f00, sp at dfec4ee0
Now running in RAM - U-Boot at: dff15000
SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB
In: eserial1
Out: eserial1
Err: eserial1
Your SYS led should be solid GREEN and you Then you should get a login screen.
Original Message:
Sent: 01-29-2021 04:24
From: Unknown User
Subject: I have issue with Juniper EX 2300
Honestly, I can not get your point, Could you explain it briefly ?
At moment , I can not change or configure this device and it shows same messages which is showing on the screenshots
I am looking forward to your reply )))
Original Message:
Sent: 01-27-2021 09:15
From: Unknown User
Subject: I have issue with Juniper EX 2300
The switch is sending output to the MICRO usb console port..
If its newer code it should finally boot and you will see console access over the rj45 port..
Original Message:
Sent: 01-27-2021 04:22
From: Unknown User
Subject: I have issue with Juniper EX 2300
I unboxed my switch and plugged in the power cable, but my sitch didn't run, I connected to it via console cable and I saw this in Terminal