set interfaces irb unit 181 family inet filter input SAN_Inbound
set firewall filter Inbound term 1 from source-address 172.31.20.0/23
set firewall filter Inbound term 1 from source-address 172.31.40.0/23
set firewall filter Inbound term 1 from source-address 172.31.60.0/23
set firewall filter Inbound term 1 from source-address 172.31.62.0/23
set firewall filter Inbound term 1 from source-address 10.68.190.0/24
set firewall filter Inbound term 1 from source-address 150.152.48.96/27
set firewall filter Inbound term 1 from destination-address 150.152.48.96/27
set firewall filter Inbound term 1 from destination-address 10.68.190.0/24
set firewall filter Inbound term 1 then accept
set firewall filter Inbound term 2 from source-address 0.0.0.0/0
set firewall filter Inbound term 2 then count traffic-deny
set firewall filter Inbound term 2 then reject
Here is ACL !!
thanks !!
Original Message:
Sent: 01-19-2021 11:52
From: CHRISTIAN SCHOLZ
Subject: VRRP assistance
Hi,
we would need to see the ACL to have a look if you accidentally filtered the VRRP Messages :)
BR
Christian
------------------------------
Christian Scholz
Juniper Networks Ambassador | JNCIE-SEC #374
Mail: chs@ip4.de
Blog: jncie.eu | Twitter: @chsjuniper | YT-Channel: netchron
Original Message:
Sent: 01-19-2021 11:03
From: Unknown User
Subject: VRRP assistance
I have the following topology.
Everything works fine until I applied an ACL for irb.181. What confused me is both MX routers became Masters if I applied ACL to IRB.181. Two MX routers still ping each other.
thanks in advance !!