Hello everybody,
I'm pretty new to juniper and also if it comes to deeper network administration ( especially routing ) I'm like a young banana, so please be gentle. :)
Also, this is the first post I'm asking for advice on because I'm struggling with this matter for weeks now.
Basically, I would like to make them VR´s communicate with each other, starting with VR VF-3 (192.168.0.0/19) and VR VDSL (10.10.0.0/24), later I would like to use the Dynamic VPN to access the different instances as well.
I've been using this article Understanding Logical Tunnel Interface (lt-0/0/0) on SRX branch series platforms - Juniper Networks to make it work but I don't seem to get it right.
Verifying OSPF for VR VF-3 and VR VDSL outputs:
root@STFWHQ> show ospf neighbor instance vdsl
Address Interface State ID Pri Dead
10.20.30.2 lt-0/0/0.1 Full 10.20.30.2 128 32
root@STFWHQ> show ospf neighbor instance vf-3
Address Interface State ID Pri Dead
10.20.30.1 lt-0/0/0.2 Full 10.10.0.1 128 35
Also, there is no active session checking the security flow.
The config without NAT rules and without Screen configurations have been attached.
------------------------------
Paul
------------------------------