Junos OS

Expand all | Collapse all

I have issue with Juniper EX 2300

  • 1.  I have issue with Juniper EX 2300

    Posted 01-27-2021 04:22
    I unboxed my switch and plugged in the power cable, but my sitch didn't run, I connected to it via console cable and I saw this in Terminal
    Can anyone help me please ?! May be someone knows about this problem??? 


  • 2.  RE: I have issue with Juniper EX 2300

    Posted 01-27-2021 09:15
    The switch is sending output to the MICRO usb console port..
    If its newer code it should finally boot and you will see console access over the rj45 port..


  • 3.  RE: I have issue with Juniper EX 2300

    Posted 01-29-2021 04:25

    Honestly, I can not get your point, Could you explain it briefly ? 

    At moment , I can not change or configure this device  and it shows same messages which is showing on the screenshots

    I am looking forward to your reply )))




  • 4.  RE: I have issue with Juniper EX 2300

    Posted 01-29-2021 04:40
    I just rebooted mine  to verify.
    On power up is your SYS light on the front of the switch blinking GREEN ?  If not reset the switch
    Then  your RJ45 console port connection will will be showing  the following for about  the next 6.5 minutes.
    ---SNIP---
    RAM Configuration:
    Bank #0: 60000000
    DRAM: New Stack Pointer is: dfec4ee0
    Relocation Offset is: eff15000
    Relocating to dff15000, new gd at dfec4f00, sp at dfec4ee0
    Now running in RAM - U-Boot at: dff15000
    SF: Detected MX25L6405D with page size 256 Bytes, erase size 64 KiB, total 8 MiB
    In: eserial1
    Out: eserial1
    Err: eserial1

    Your SYS led should be solid GREEN and you Then you should get a login screen.