Hello,
my name is Denis, I hope that is the good community to ask my question to...
I do use a fresh srx 340 cluster.
I created en reth interfaces attached to several vlan. Each vlan is part of a zone.
My problem is that when i test performance between 2 zones by using iperf3 for example, event it is attached to a gigabit ethernet link, transfert is no more than 150 Mb/s if i am lucky.
Iptraf pps is quite low and when i do that, the latency on the whole network is high between zone (around 70/80 ms)
Only a few firewall rules between zone (mostely allow all policy for testing purpose for debuigging).
the web interface show PFE-CPU to 100% during the test.
i tried various debug command without having a chance to find ou anything...
show pfe statistics traffic show only a few pps (around 10K when i test it)
Not using UTM (deactivated, no licence) , not using IDP.. only attached reth1.xxx to my zone (around 10 zones).
Using bgp with only default route (no full table). only a few nat rules (source and destination). no nat between zone.
So help will be more than welcome...
regards,
Denis
------------------------------
DENIS ALLIGAND
------------------------------