Junos OS

Hi,

I have juniper QFX 5120-32C, which has 32x100G ports and 2x10G ports.

Model: qfx5120-32c
Junos: 19.1R1.6 flex

All 32 ports working fine and can also fan-out, but the last 2 port which I want to use as uplink, is not seen in the show interface terse

{master:0}[edit]
admin@LEAF-01# run show interfaces terse
Interface Admin Link Proto Local Remote
gr-0/0/0 up up
pfe-0/0/0 up up
pfe-0/0/0.16383 up up inet
inet6
pfh-0/0/0 up up
pfh-0/0/0.16383 up up inet
pfh-0/0/0.16384 up up inet
et-0/0/0:0 up up
et-0/0/0:0.0 up up inet
########### Omitted##############
et-0/0/16:0 up up
et-0/0/16:0.0 up up inet
et-0/0/16:1 up up
et-0/0/16:1.0 up up inet
et-0/0/16:2 up up
et-0/0/16:2.0 up up inet
et-0/0/16:3 up up
et-0/0/16:3.0 up up inet
xe-0/0/17:0 up up
xe-0/0/17:0.0 up up inet
xe-0/0/17:1 up up
xe-0/0/17:1.0 up up inet
xe-0/0/17:2 up up
xe-0/0/17:2.0 up up inet
xe-0/0/17:3 up up
xe-0/0/17:3.0 up up inet et-0/0/30 up up
et-0/0/30.0 up up aenet --> ae0.0
et-0/0/31 up up
et-0/0/31.0 up up aenet --> ae0.0
ae0 up up
ae0.0 up up eth-switch
ae32 up down
ae32.0 up down eth-switch
bme0 up up
bme0.0 up up inet 128.0.0.1/2

ALso trying to configure forcefully

stilll the port is not shown in the list

}
xe-0/0/32 {
unit 0 {
family ethernet-switching {
vlan {
members v108;
}
}
}
}
xe-0/0/33 {
unit 0 {
family ethernet-switching {
vlan {
members v108;
}
}
}
}

Any suggestions

Help is appreciated

Do you have optics installed? What is the output of show chassis hardware?

Hi

Can you paste the output of show chassis hardware from the device to confirm if the SFPs are plugged in the 2 SFP ports ?

Xcvr 31 REV 01 740-061000 1P1C40A43849D QSFP28-100G-CU1M
Xcvr 32 NON-JNPR T03A5N11728 SFP28-25G-BASE-SR
Xcvr 33 NON-JNPR T03A3N01276 SFP28-25G-BASE-SR

Have asked the remote team to replace the SFP, relpacing the SFP shud work fine....

Thnks guys