We have an EX2300 switch which have been configured with this command :
delete protocols rstpset protocols mstp configuration-name region1set protocols mstp revision-level 20set protocols mstp interface all edgeset protocols mstp bpdu-block-on-edge
How could we get back the default RSTP protocol please with the default options ? please put the command if you could...
Thanks a lot !
It depends a bit on how many ports the switch has, but the general commands would look something like this:
delete protocols mstp
wildcard range set protocols rstp interface ge-0/0/[0-23]
wildcard range set protocols rstp interface ge-0/1/[0-3]
wildcard range set protocols rstp interface xe-0/1/[0-3]
The 23 above is for a 24-port switch, and would be replaced by 47 for a 48-port model.
Why don't you simply rollback config?
I just have to manage this EX2300 and i looking just to change to rstp without searching in all the rollback things that could be necesseray for the switch...
So it's not necesseray to make this command :
wildcard range delete protocols mstp interface ge-0/0/[0-X]
and things like :
delete protocols mstp bpdu-block-on-edgedelete protocols mstp revision-level 20delete protocols mstp configuration-name region1
The "delete protocols mstp" do all ?
Thanks again .
You are correct, "delete protocols mstp" will delete everything "under" mstp as well.
and endlly..... It's not necesseray to run this general command after the "delete protocols mstp" : "set protocol rstp"
If it exists....
Thanks again and again !