If the remote VTEP has multiple loopback addresses with one defined as primary. In local VTEP, the following command should list only remote primary loopback IP, or all the loopback IPs ?
If multiple remote loopback IPs are listed, any issues will occur ?
root@vQFX-2# run show ethernet-switching vxlan-tunnel-end-point remote
Logical System Name Id SVTEP-IP IFL L3-Idx SVTEP Mode
<default> 0 192.168.1.2 lo0.0 0
RVTEP-IP IFL-Idx NH-Id RVTEP Mode
192.168.1.1 574 1782 RNVE
VNID MC-Group-IP
104 0.0.0.0
103 0.0.0.0
102 0.0.0.0
101 0.0.0.0
RVTEP-IP IFL-Idx NH-Id RVTEP Mode
192.168.1.10 573 1780 RNVE
VNID MC-Group-IP
104 0.0.0.0
102 0.0.0.0
103 0.0.0.0
101 0.0.0.0
both 192.168.1.1 and 192.168.1.10 are the loopback addresses on the same remote VTEP. I have the above output on vQFX 18.4.
Any documentation for this ?
thanks !!