I am trying to understand how event-options work.
I have the following:
vQFX .2 -------10.10.10.0/24 ------- .1 vMX lo0.0 192.168.10.1
.2 ------- 10.10.20.0/24 ------- .1
root@vQFX-1# show routing-options | display set
set routing-options static route 192.168.10.1/32 next-hop 10.10.10.1
set routing-options static route 192.168.10.1/32 qualified-next-hop 10.10.20.1 preference 7
root@vQFX-1# run show route protocol static
inet.0: 7 destinations, 8 routes (7 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
192.168.10.1/32 *[Static/5] 03:03:07
> to 10.10.10.1 via xe-0/0/0.10
[Static/7] 03:03:07
> to 10.10.20.1 via xe-0/0/0.20
RPM
root@vQFX-1# show services rpm | display set
set services rpm probe failover test icmp-test probe-type icmp-ping
set services rpm probe failover test icmp-test target address 10.10.10.1
set services rpm probe failover test icmp-test test-interval 2
set services rpm probe failover test icmp-test thresholds successive-loss 3
event-options
root@vQFX-1# show event-options | display set
set event-options policy failover events route-failover
set event-options policy failover within 30 trigger on
set event-options policy failover within 30 trigger 2
set event-options policy failover within 45 trigger until
set event-options policy failover within 45 trigger 3
set event-options policy failover attributes-match route-failover.test-owner matches failover
set event-options policy failover attributes-match route-failover.test-name matches icmp-test
set event-options policy failover then change-configuration commands "set routing-options static route 192.168.10.1 next-hop 10.10.10.1 preference 10"
I expected to failover to 10.10.20.1 after a few pings fail.
but it does not work.
Any insights ?
thanks in advance !!