I have the following:
set services rpm probe icmp-probe test icmp-test probe-type icmp-ping
set services rpm probe icmp-probe test icmp-test target address 30.30.30.1
set services rpm probe icmp-probe test icmp-test test-interval 2
set services rpm probe icmp-probe test icmp-test thresholds successive-loss 3
set services ip-monitoring policy icmp-policy match rpm-probe icmp-probe
set services ip-monitoring policy icmp-policy then interface ge-0/0/3 disable
After rpm failed, the interface ge-0/0/3 is disabled, but the interface ge-0/0/3 does not automatically recover when the remote interface is recovered.
what did I miss here ?
How to manually enable the interface ge-0/0/3 after it is disabled by rpm ?
thanks in advance !!