vMX

Expand all | Collapse all

Load balancing over LSP on MX

Jump to Best Answer
  • 1.  Load balancing over LSP on MX

    Posted 06-06-2020 22:03

    Hi everybody,

    I am trying to understand how traffic can be load balanced over two LSP .

    I stumbled upon this Juniper KB:

    https://kb.juniper.net/InfoCenter/index?page=content&id=KB12995&actp=METADATA

    Capture-TEST.PNG

     

    As per link, following is configured on ingress Chewie:

    forwarding-options {
        hash-key {
            family mpls {
                label-1;
                label-2;
                payload {
                    ip;

     

    lab@Chewie> show route forwarding-table destination 10.1.1.3 
    Routing table: inet
    Internet:
    Destination        Type RtRef Next hop           Type Index NhRef Netif
    10.1.1.3/32        user     0                    ulst 262143     1
                                                    Push 299824       t1-2/0/1.0
                                                    Push 299808       t1-2/0/0.0

    Above we see Chewie will load balance traffic destined to 10.1.1.3/32 over two LSP.

     

    Are we saying:

    1) if Chewie ( ingress LSR) receives MPLS labled packets , it will use MPLS lable1 , label2 and ip load to compute hash key for load balacing?

    If above is true, how about traffic which is not labelled ?  for example, Igress LSR ( Chewie) issues pings to 10.1.1.3 , which is not labelled yet , how Chewie load balance traffic over these two LSP as there is no MPLS lablels but our load balancing configuration , as shown in forwarding option at the start of this post,  says please factor MPLS label1 , label2 and IP pay load to compute hash?

     

    Thanks and have a good night!!

     

     



  • 2.  RE: Load balancing over LSP on MX
    Best Answer

    Posted 06-06-2020 22:32

    Hello,

    You found a VERY OLD article 🙂

     

    Load-balancing traffic over RSVP-based MPLS Label-switched paths (LSPs)