Routing

 View Only
last person joined: 2 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

QFX5110 problem with passing through mpls traffic/l2circuit

  • 1.  QFX5110 problem with passing through mpls traffic/l2circuit

    Posted 04-08-2021 16:00
      |   view attached


    We started the implementation of QFX5110 and faced the problem that there is no traffic inside l2circuit if the path goes through QFX. It's not with  mpls-te, and is'n work when change igp (ospf) cost for only ldp signalling. All labels is correct on the both directions and signaling are correct - L2 is up, but there is no ping inside the channel. at the same time, If mpls hop is mx80-cisco-cisco-cisco l2circuit works correctly. Also we have some mx80 – it implementation well – l2circute works on  path mix with cisco and mx.

    We check some firmware 18.4r1, 18.4r2, 19… now it's 19.4R3-S2.2.

    We experiment with configurations of interfaces:

    Unit with mpls p2p, l2 switching with irb and l3-int on vlan
    Perhaps someone has some ideas on how to make the device work with the declared functionality.