Hello,
I'm trying to configure a MX104 router at work for a lab.
We resetted the device and are trying to set a new configuration.
To have remote access to the device we want to set the management interface, through the fxp0 interface. We connected a RJ45 cable from the fxp0 to a switch that gives us a management access to every device in the lab.
The interface is "up up" on the switch, and when we disconnect the cable from the fxp0 of the MX104, the interface on the switch turns "down down (not connect)", so that's not a cabling issue.
On the MX104, the fxp0 is always 'admin down' and I didn't manage to enable it so that it would have turned to "up up", with any common cli commands (delete interface fxp0 disable...etc // the interface configuration doesn't show basically any disabling state...)
Could you please provide some help?
Here are some informations on the device:
Model: mx104
Junos: 13.3R1.8
Here are the status of the interfaces (I can't enable any of them...):
>show interfaces terse
Interface Admin Link Proto Local Remote
dsc down up
em0 down up
em1 down up
fxp0 down upgre up up
ipip up up
lo0 down up
lsi up up
me0 down up
mtun up up
pimd up up
pime up up
tap down up
>
show interfaces fxp0Physical interface: fxp0, Administratively down, Physical link is UpInterface index: 67, SNMP ifIndex: 0
Type: Ethernet, Link-level type: Ethernet, MTU: 1514
Device flags : Present
Interface flags: Down SNMP-Traps No-receive
Link flags : None
Current address: 84:c1:c1:63:fc:77, Hardware address: 84:c1:c1:63:fc:77
Last flapped : Never
Input packets : 0
Output packets: 0
Thank you in advance!