Hi Jonas,
Thank You for maling that clear. I have an ex i Can use fir it.
Hi Carsten, to have three devices connected to the same /29 on the SRX4100, you need an external switching device to provide the layer2 bridge... -posted to the "Routing" community
You are receiving this message because you followed the 'srx4100' message thread. To unsubscribe from this message thread, go to Unsubscribe. Update your email preferences to choose the types of email you receive | | |
Original Message:
Sent: 2/7/2021 8:07:00 AM
From: jonashauge
Subject: RE: srx4100
Hi Carsten,
to have three devices connected to the same /29 on the SRX4100, you need an external switching device to provide the layer2 bridge domain.
------------------------------
--
Jonas Hauge Klingenberg - Juniper Ambassador
------------------------------
Original Message:
Sent: 02-07-2021 07:47
From: Unknown User
Subject: srx4100
Hi Jonas,
I took the config from a srx320. I would like to have a /29 on a collection of 3 ports, and be able to nat til it.
Thank You.
With kind regards
Carsten Rønne
Original Message:
Sent: 2/7/2021 6:53:00 AM
From: jonashauge
Subject: RE: srx4100
Hi,
A Steve states, the feature is not supported on other than the mentioned platforms. The SRX4100/4200 are CPU-based platforms without any switching ASIC so the feature is not needed on this platform the operate correctly.
That said, doing swithports on the interfaces it not possible either and you need a switch separately to do this.
What are you trying to accomplish? Or have you just taken a configuration from a SRX300 and tried to migrate it to SRX4100?
------------------------------
JONAS HAUGE KLINGENBERG
Original Message:
Sent: 02-05-2021 07:10
From: Unknown User
Subject: srx4100
Hi,
Thank you for responding.
Right now I need to set protocols l2-learning global-mode switching
But I can't – it says not supported on platform
Do you know the command to set it?
Carsten Rønne
Original Message:
Sent: 2/5/2021 5:47:00 AM
From: spuluka
Subject: RE: srx4100
Can you post the error message you get on the config and perhaps a sanitized version of the config for review?
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
http://puluka.com/homeOriginal Message:
Sent: 02-04-2021 10:46
From: Unknown User
Subject: srx4100
Hi,
I have a factory default set srx-4100. How do i set the l2-learning global-mode to switching?
I have a config from srx-320 i would like to commit but i fails and i need to configure it so my irb's are working.
Do any of you know this?
Thank you in advance