Have some questions about traffic on MS-MIC-16G
At first look at scheme
It describes how I understand traffic flow in MX80 when using MX-MIC-16G fro NAT
Green lines input, red lines - output
Overall traffic on ms-0/2/0(Input/Output) = 5Gb/5Gb
Traffic on ms-0/2/0.100 (Input/Output) = 1Gb/4Gb
Traffic on ms-0/2/0.200 (Input/Output) = 4Gb/1Gb
Spec says max throughput for MS-MIC-16G is 9Gb
So, question is: 9Gb max thoughput, for one of directions, can be reachable on ms-0/2/0 interface?
Or, 9Gb is maximum for subinterfaces ms-0/2/0.100 and ms-0/2/0.200?
Many thanks in advance who will clarify me this moment.
I guess (since throughput put is something which is calculated based on the amount of data can be processed in a given time) it's overall throughput
MS-MIC (and MS-MPC and MS-DPC) t'put is the sum of all traffic passing through in all directions on all subinterfaces.
Taking Your diagram as example topology, You can have as a maximum:
1/ 1Gbps down and 8Gbps up, spread across all MS subinterfaces
2/ 2Gbps down and 7 Gbps up, spread across all MS subinterfaces
3/ 3Gbps down and 6 Gbps up, spread across all MS subinterfaces
. . .
XX/ 8Gbps down and 1Gbps up, spread across all MS subinterfaces
The max number of MS subinterfaces You can configure on MS-MIC is in order of several thousands.
Normally, when You do interface-style services, You have 1 subinterface.
Normally, when You do nexthop-style services, You have 1 "inside" subinterface and 1 "outside" subinterface, marked as such in the configuration. In certain cases You can have >1 "inside" subinterfaces mapped to 1 "outside" subinterface when doing i.e. IPSec at scale.
Interface-style and nexthop-style service-sets are described in this book https://www.juniper.net/uk/en/training/jnbooks/day-one/networking-technologies-series/cgnat-up-runnning-mx-series/ , chapter 1.
Do I understand correctly that if I have updown 5 and upload 5 on the ms-0/2/0 interface (when using the next-hop style) (the sum from all subinterfaces), then I already need to add a new card?