Routing

Hi all,

 

Last week i have upgrade junos on MX480 production. During the upgrade the RE0 was faulty then i take it the spare lab unit and upgrade it on lab chassis and after that i take out and put into production unit. Then i do commit synch from RE1 (master) to make sure the config sync to RE0. After that i get log as per below and it keep appear. It's look like something process / taks still pending. Can someone guide me how to check and clear it?

 

{master}

test@MX480-re0> edit private

warning: uncommitted changes will be discarded on exit

Entering configuration mode

Users currently editing the configuration:

  sync-other-re (pid 9335) on since 2019-01-29 03:09:21 MYT, idle 4d 05:30

  sync-other-re (pid 9377) on since 2019-01-29 03:09:31 MYT, idle 4d 05:30

  sync-other-re (pid 9415) on since 2019-01-29 03:09:38 MYT, idle 4d 05:30

  sync-other-re (pid 9467) on since 2019-01-29 03:09:45 MYT, idle 4d 05:30

 

Thanks and appreciate someone feedback

Hi Kronicklez,

Please see this: https://prsearch.juniper.net/InfoCenter/index?page=prcontent&id=PR1221723

As workaround, perform "request system logout pid <PID>" for each of the pids seen in the error output.

Hope this helps.

Regards,
-r.

--------------------------------------------------

If this solves your problem, please mark this post as "Accepted Solution."
Kudos are always appreciated :).</PID>

Also, you could check "show system processes extensive | grep <pid>" for these PIDs to look if they're still used by the kernel on each RE.  On backup RE, you can login "request routing-engine login other-routing-engine" and check the same.  Either ways, PR1221723 is the resolution.

 

 

Hope this helps.

Regards,
-r.

--------------------------------------------------

If this solves your problem, please mark this post as "Accepted Solution."
Kudos are always appreciated :).

Hi mriyaz,

 

 

It's work!!.

 

Thanks