Thanks for your reply, i am sharing cisco output. I am searching like that.
show running-config all
interface Ethernet1/1
description With-SAR-2-Port-Ge-1/1/6
lacp port-priority 32768
lacp rate normal
lldp transmit
lldp receive
no lldp tlv-set management-address 0.0.0.0
no lldp tlv-set management-address ::
no lldp tlv-set vlan
cdp enable
switchport
switchport mode trunk
no switchport monitor
no switchport dot1q ethertype
switchport access vlan 1
switchport trunk native vlan 1
no switchport vlan mapping enable
switchport trunk allowed vlan 1-3,21-228,230-413,415-443,445-504,507-559,562-570,572-577,579-4094
priority-flow-control mode auto
spanning-tree port-priority 128
spanning-tree cost auto
spanning-tree link-type auto
spanning-tree port type normal
no spanning-tree bpduguard
no spanning-tree bpdufilter
speed 1000
duplex auto
fec auto
flowcontrol receive off
flowcontrol send off
link debounce time 100
no beacon
mtu 1500
delay 1
snmp trap link-status
negotiate auto
logging event port link-status default
logging event port trunk-status default
storm-control broadcast level 100.00
storm-control multicast level 100.00
storm-control unicast level 100.00
no storm-control action
bandwidth 1000000
no bandwidth inherit
load-interval counter 1 30
load-interval counter 2 300
no load-interval counter 3
no switchport block multicast
no switchport block unicast
no switchport mac-learn disable
no shutdown lan
no switchport autostate exclude
channel-group 1
no shutdown
#####################################################
show running-config
interface Ethernet1/1
description With-SAR-2-Port-Ge-1/1/6
switchport mode trunk
switchport trunk allowed vlan 1-3,21-228,230-413,415-443,445-504,507-559,562-570,572-577,579-4094
speed 1000
channel-group 1
------------------------------
UJJAL BS
------------------------------
Original Message:
Sent: 05-18-2021 08:05
From: Unknown User
Subject: how to see juniper full configurations?
I know what your meaning. I had a hard time for a while to deal with this.. | display set is a comfortable way to start off .
Since Junos does not exclude things you will see it all. If you do groups you want to expand those associated configs
show int ge-0/0/0 | display set | display inheritance
Original Message:
Sent: 05-17-2021 12:28
From: UJJAL BS
Subject: how to see juniper full configurations?
operational mode ">show configuration" or in configuraiton mode "show, show | display set" will provide configured configuration. I want to see juniper's default settings/configurations like cisco "show running-config all". Basically need to see juniper's default configurations like ddos,bgp,ldp,stp
------------------------------
UJJAL BS
------------------------------